It’s an old, silly riddle: how many grooves on a record? Of course, the answer is just one on each side—but that groove is usually about 1,500 feet long, or about 1/3 of a mile. If Wikipedia is correct, the record player’s needle, or, correctly, the stylus, runs that distance at an average speed of about 1 mph (but travels faster on the outside edge of the record, more slowly on the inside). According to GZ Vinyl—the world’s largest producer of vinyl records—the average width of the groove is 0.04 – 0.08 mm, or 40 to 80 microns (micrometers), roughly the width of human hair, or about 1/10 the size of a grain of sand. And if the groove is that wide, the tip of the stylus must be small enough to fit comfortably inside that groove. A conical stylus (there are several shapes) is about half the width of the groove. The various bumps, ridges and other material inside the groove, the physical manifestation of sound on the record—are smaller still. A particle of dust may be larger than the stylus itself (think in terms of a bulldozer pushing a boulder of equal size), which why serious vinyl listeners are so fastidious about keeping record surfaces clean (even washing them with machines costing over $1,000).
The LP was introduced in 1948, with stereo recordings available about a decade later. Seventy years later, the technology is still in use—and still astonishing. From 1960 until 1987, the LP was the dominant recorded music format. After 25 years of just-hanging-in, the LP is making a comeback, this time hailed as the second-best consumer format (reel-to-reel might be first, but that’s another story). Nowadays, listening to records can involve a very sophisticated technology journey, hence this and several other articles on Digital Insider.
Usually made from a diamond, the stylus is the sensitive tip of a thin pipe called a cantilever, which extends downward, at an angle, from the inch-long box called a phono cartridge, which is, in turn, mounted to the end of the turntable’s tone arm. In the words of Robert Harley, author of The Complete Guide to High-End Audio, “The phono cartridge has the job of converting the modulations in record groove into an electrical signal…The stylus is moved back and forth and up and down by modulations in the record groove.” (Inside the cartridge), magnets and (incredibly small) coils (of wire) work together as an electrical generator to create output voltage…(also known as the) audio signal.” In a moving magnet (“MM”) cartridge design, the magnets move to induce the output and the coils remain stationary; in a moving coil design (“MC”), the magnets remain stationery and the coils move.
Regardless of the type of cartridge, the resulting audio signal is very modest, and requires substantial amplification in order to be heard and enjoyed. I found it difficult to calculate the amount of amplification, but I’m guessing the sound you’re hearing from the loudspeakers is easily a hundred times the volume of the sound you’re hearing if you listen really closely to the stylus making contact with the surface of the LP. (Engineers, please comment and correct.)
Before we move on to specific types of equipment, consider this: the tiny stylus is likely to pick up not only the sound from the grooves in the record (and the inevitable scratches, clicks and pops), but also the sound of the turntable’s motor, the resonance of the tonearm, and any other sounds in the room, including conversations, dog barks, and other disturbances. For cartridge, tone arm, and turnable manufacturers, playing the design game requires tremendous attention to mitigation and near-elimination of vibration, resonance, and other unwanted sounds. At the same time, a properly-designed cartridge must make the very best of the available (physical) information inside the grooves of every record. Fortunately, every record is made in accordance with very precise manufacturing standards (in the U.S., RIAA standards were established in 1963). Unfortunately, record pressings (the actual physical manufacture of each vinyl record) vary in quality. (I’ll write a separate article about record pressing and how to choose the best records.)
So: we’re now going to shop for a product that we can neither see nor touch, which must be mounted on turntable, which is in turn connected to several types of amplifier (phono stage pre-amplifier, pre-amplifier, power amplifier), and then to a pair of loudspeakers—each connected by a pair of cables that affect the quality of the sound, mounted on tables and stands with varying degrees of sound isolation and vibration, connected to AC power which often introduces its own issues, in listening rooms whose acoustic design and loudspeaker placement greatly affects fidelity. And through this process, we’re hoping to evaluate the microscopic interaction between a tiny diamond stylus tip, a cartridge, and a record whose pressing may or may not be up to snuff. Some audio dealers are patient with listeners who are trying to making the right decision; others have seen too many customers come and go, and then buy online, so these dealer’s lack of patience is a rational response to a nearly-nonsensical marketplace.
Fortunately, there are a fair number of audiophiles who listen to all sorts of equipment, and share their opinions. Chad Stelly, who works at Acoustic Sounds, is one of the best in the business, but I probably spoke with, or emailed, or read opinions from twenty or thirty knowledgeable people. Generally, they thought my current choice of a Shure V15vx was more than suitable for my Rotel RP900 turntable, a combination that kept me happy for several years. Now that I wanted more, everyone asked whether I would keep a very solid (apparently Rega-built) turntable, or upgrade. Assuming an upgrade, I wanted something that would take me to a new level of enjoyment. Seeking any meaningful consensus, I listened, read, and studied online reviews (well-respected audiophile publications can publish only so many cartridge reviews, so I filled-in with message board comments).
Grado was the first recommendation. In particular, several advisors suggested the Grado Sonata2 ($600), but several reviews pointed up the line to the Reference Master2 ($1,000). These cartridges are made from a particular type of rare Australian wood, presumably adding warmth to the sound, but several dealers told me that Grado cartridges were wonderful in the mid-range, but there would be better options for the more extreme highs and lows. In my informal surveys, Grado was always among the top recommendations—but never the top recommendation because of the potential for hum and noise—but only under particular circumstances (how could I test this in a store—not easily, it turned out, because dealers don’t like to open and swap out cartridges that destroy the original packaging). In the future, I plan to spend serious time experimenting with these and other Grado cartridges and developing my own opinion.
I learned about Soundsmith, and in particular, the Carmen ($800) and the Boheme ($1,200), but I never found them in any store—though everyone talked about how great Soundsmith might be for my situation. I learned about matching a particular cartridge to a particular phono pre-amp (“Hmmm… the Boheme might sound a little bright with the Sutherland Insight phono stage…”) One person suggested a Hana EL or EH elliptical ($475). Several friends told me they liked Ortofon cartridges—but there are fifty different models. Through too much time spent online and in more conversations, we narrowed the Ortofon search to the Quintet Black S ($999) and Bronze ($839).
Unable to even find most of the cartridges connected to a turntable at a local dealer, I just kept reading online reviews and talking to anybody who seemed knowledgeable. That’s how I found my way to Dynavector. I listen to opera, choral music, classical, jazz, blues, rock and pop, bluegrass—the connection between them seems to be emphasis on voice and acoustic over electric or highly produced recordings. When I began to ask about the Dynavector DV20x20, people started telling me that this was the right cartridge for me, especially if I intended to upgrade the turntable in the future.
So l started listening. Or, first, I paid a local audio dealer to mount to cartridge properly—this is not an easy thing to do properly—and then I started listening to the DV20x20 on my Rotel RB900 turntable. I started with a favorite orchestral performance that I’ve written about before: Karl Goldmark’s Rustic Symphony conducted by Leonard Bernstein. I like the recording, in part, because it’s well-organized for critical listening: double basses and cellos, then violins and violas, then the winds, and so on. I was impressed by the difference that I could hear when I replaced my 20-year old, $200 phono stage with a significantly better Sutherland Insight phono stage pre-amp. Now, I hoped to hear a substantial improvement by replacing the Shure V15vx phono cartridge with the Dynavector DV20x20. Sure enough, I heard what I hoped to hear—immediately! The low strings were even more clearly defined, distinct from one another, with greater body, more luxurious fluidity, and a greater sense of presence, and, looking for a word here…snap! Moving to the higher strings, they gained a sense of reality, smoothness, and again, presence. The winds can tend to be a bit screechy on this recording, but they were nicely managed by this cartridge. I tried a few chamber recordings, some solo female voices, and found myself completely charmed by Linda Ronstadt’s wonderful voice on Canciones de mi Padre, her 1987 album of Mexican songs that I bought for $3 in wonderful condition from a used record store.
When I’m listening to a new piece of equipment—something I don’t do very often, to be honest, because I make my decisions with such care—one subjective test is how often I swap records. If I find myself sitting and listening, often to a whole side of an LP, I know that I’ve found a winner. So now I’m spending hours listening, and rediscovering discs that I know pretty well—and finding new joy because there is more detail, punch, clarity, and sense of being there with so many LPs. I’m very impressed by the Dynavector DV20x20, and I’ll attempt to close out with the reasons why. On classical recordings, I find the overall presence most appealing, closely followed by the punch and sweep of the more exciting passages, and increased refinement of solo violins, female voice, clarinets, oboes, and flutes. On jazz recordings, it’s undoubtedly the crispness of the drum kit—so precise, with just the right sense of attack and decay—though I do love what happens when I listen to Oscar Peterson playing piano, and I know that because I now find it difficult to listen to him as background music. I pay more attention to the music! On rock LPs, it’s the bass and the percussion that gets me, but also the higher tinkering on an electric or pedal steel guitar. When I listen to a singer, I hear nuances that I’m not sure I heard, or paid attention to, before. In short, this tiny component—a phono cartridge half the size of my pinky—is providing a whole lot of enjoyment.
And although I won’t disclose everything in this article, I will say that I’m on the second day of listening to the same Sutherland Insight phono stage, and the same cartridge but now on a much-improved turntable. So far, I’m very happy, but I’ll tell you more after some in-depth listening. With a VPI Prime turntable.
This article is part of a series.